Seneca Z-PASS1, Руководство пользователя

Страница: 57 / 155

USER MANUAL – Z-PASS1/Z-PASS2
57
Default URL for user pages:
https://<IP_address>
FILE TRANSFER/Protocol Protocol used for File Transfer:
FTP/SFTP, SFTP, FTP FTP/SFTP
FTP Port TCP Port for FTP protocol 21
SFTP Port TCP Port for SFTP protocol 22
NETWORK REDUNDANCY/Enable Flag to enable/disable the
“Network Redundancy”
functionality, that is using the
Ethernet interface as the primary
interface to access the Internet and
the Mobile interface as the
secondary interface, if the access
through the primary interface
becomes unavailable
OFF
NETWORK REDUNDANCY/Ping
Address IP Address used as ping destination
to check if access to the Internet
through the primary interface
(Ethernet) is available.
This address shall be different from
the one set for “DNS Server”
parameter, otherwise an error is
shown (see figure below). 8.8.4.4
WATCHDOG/Enable Flag to enable/disable the
watchdog functionality
ON
WATCHDOG/Timeout (s) Watchdog timeout, in seconds;
when watchdog is enabled, if it’s
not refreshed for this amount of
seconds, the system will be
rebooted.
Possible values are in the range
[30..3600]. 60
DEBUG LOGS/Enable Flag to enable/disable the debug
logs OFF
COM1/Mode Operating mode of the COM1 serial
port
Possible values: RS485 | RS232
This parameter is available only for
Z-PASS1-IO
and Z-PASS2-IO
products.
RS485
One note about the “DHCP” parameters:

the “DHCP” parameter can be set to “ON” only if the “DHCP Server” parameter of the “Router
Configuration” page is set to “OFF” (see paragraph 18.8).