Seneca Z-PASS1, Руководство пользователя

Страница: 55 / 155

USER MANUAL – Z-PASS1/Z-PASS2
55
In the following table, all configuration parameters available in this page are listed, with a short explanation
and the parameter default value for each of them.
Field Meaning Default value
NETWORK/Ethernet Mode This parameter determines if the
two Ethernet ports work as two
fully separated network interfaces
(“LAN/WAN”) or as the ports of an
Ethernet
switch (“Switch”);
depending on the value of this
parameter, some other network
parameters are hidden/shown or
renamed as described below.
This parameter is available only for
Z-PASS1-R01,
Z-PASS2-R01, Z-
PASS1-IO and Z-PASS2-IO products.
For Z-PASS1 and Z-PASS2 products,
only “Switch” mode is available,
hence the parameter is not shown.
LAN/WAN
Ethernet Mode = “Switch”
NETWORK/DHCP
Flag to enable/disable the DHCP
functionality on the Ethernet
interface. OFF
NETWORK/IP Address IP address of the Ethernet interface
(disabled when “DHCP” is set to
“ON”) 192.168.90.101
NETWORK/Network Mask Network mask of the Ethernet
interface (disabled when “DHCP” is
set to “ON”) 255.255.255.0
NETWORK/IP Address 2 Enable Flag to enable/disable the second
IP address on the Ethernet
interface.
Note that the second IP address
can be enabled also when the
DHCP functionality is active. OFF
NETWORK/IP Address 2 Second IP address of the Ethernet
interface 192.168.100.101
NETWORK/Network Mask 2 Second network mask of the
Ethernet interface 255.255.255.0
Ethernet Mode = “LAN/WAN”
NETWORK/DHCP on WAN
Flag to enable/disable the DHCP
functionality on the WAN Ethernet
interface ON
NETWORK/LAN IP Address IP address of the LAN Ethernet
interface 192.168.90.101