Seneca S6001-RTU, Руководство пользователя

Страница: 30 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
30
Run 1 Red Blinking Run
Level switch L1, L2 Green OFF, OFF (value 0)
ON, OFF (value 1)
ON, ON (value 2)
Under min level
Between min and
max levels
Over max level
Following are some further notes about LED behavior:

at power on, during the bootstrap phase, all LEDS, except for the COM PORT LEDs, are ON; when
the system is fully operational, RUN LED is blinking

when Straton application is not running, all LEDS, except for the COM PORT LEDs, are blinking

3G PWR SIG LED 1 is blinking, synchronously with RUN LED, in the following situations:
o
GSM/3G network is not available (or signal level is too low)
o
SIM is not inserted
Modem LEDS
LED Status Meaning
3G PWR Green ON The 3G Modem is powered on
STAT Yellow ON
Slow Blinking
Fast Blinking
Not registered on GSM network
Registered on GSM network
Mobile Network connection active
6 Discovering the IP address
Z-TWS4/Z-PASS2-S/S6001-RTU devices come out of the factory with the default 192.168.90.101 IP address
on the Ethernet network interface.
If this address is changed, and forgotten, it can be retrieved by running the “Seneca Device Discovery”
(SDD) application, as shown in the following figure: