Seneca S6001-RTU, Руководство пользователя

Страница: 89 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
89
Result (Status)
The following table gives a short explanation of the possible “Result” and “Status” strings:
Result Status Meaning
Error (Unexpected response) A response code has been received that is not
handled by the Device (it should never occur)
Error (No response from VPN
Box) No response has been received from the VPN Box
(response timeout); this is normally due to
connectivity problems
Error (Invalid response from
VPN Box) A response has been received whose content is
not valid for the Device (it should never occur)
Error (Wrong password) The password set on the Device is wrong
Error (License Limit Reached) The maximum number of devices allowed by the
license are already registered on VPN Box
Error (VPN Box not configured) The VPN Box has not been configured yet
Error (Generic error) A generic error has occurred on the VPN Box
OK The Device has just been registered on the VPN
Box
OK New The Device is registered on the VPN Box, but it is
not configured yet (“Single LAN” only)
OK Configuration updated The Device configuration has just been updated
OK Configured The Device is properly configured and available
for VPN connection
OK Ban The Device has been banned
OK Not found The Device is unknown for the VPN Box; this
happens when Device registration is deleted on
the VPN Box
OK Unknown The Device has an “unknown” status in the VPN
Box (it should never occur)
OK Not bound The “tunnel” between the Device and the VPN
Box is not up; this may occur when the tunnel
port is blocked (“not open”) in the ADSL router
on the VPN Box side (“Point-to-Point” only)
OK Unexpected status A status code has been received that is not
handled by the Device (it should never occur)
You can refresh the VPN status, by clicking on the “REFRESH” button.
Finally, you can hide the “VPN Status” section, by clicking on the “HIDE VPN STATUS” button.
18.1.4.2.1 LED signalling (Z-PASS2-S-R01/Z-PASS2-S-IO/Z-TWS4-IO)
In Z-PASS2-S-R01/Z-PASS2-S-IO/Z-TWS4-IO products, when VPN functionality is enabled in “VPN Box/Single
LAN” mode, the “SERV” and “VPN“ LEDs give the following status information (see chapter 5):
LED Status Meaning
VPN Yellow ON VPN connection is working properly