EN
49
commeo commissioning/setting by radio
Note for settings under point 5.2.: The drive must be selected for these settings with a
transmitter in SELECT mode (status LED slowly flashes orange). After the setting has been
configured, the drive is still selected (see point 5.).
5.2.1. Semi-automatic setup mode WITH relief
in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position!
The lower end position must be approached first. From here, move to the upper limit stop
without interruption until the drive is automatically switched off.
Operation
Movement
9 s
Press the STOP button on the transmitter for 9 seconds.
Both previously set end positions are deleted.
Note: Can be omitted during the initial installation or
after resetting to the factory settings.
or
STOP
STOP
Move the drive downwards to the required lower end
position using the UP or DOWN button.
STOP
STOP
From here, move to the upper stop without interrup-
tion. The drive stops automatically.
This correctly sets the direction of rotation. Perform a
test run. The drive moves upwards against the stop and
is briefly relieved.
Note: The transmitter may not have been programmed
yet. To programme a transmitter, see point 5.2.4.
