Sekotech ST-300 SPIDER, Руководство по эксплуатации, Страница: 16 / 68

ST300 SPIDER
14
Similarly, set the required values for
“
MONTH
”
and
“
YEAR
”
. If
“
ESC
”
is pressed before confirming the
entered values, they will not be saved, and the device will exit the clock setting mode. All confirmed
values will remain in the device’s memory on exiting the setting menu, and will stay saved even when
the power is switched off.
2.3.2 Time Setup
To set the time, in the
“
SETTINGS
”
menu move the cursor to the
“
TIME
”
field using the and keys, and press
“
ENTER
”
.
The time setting menu will appear on the screen (Fig.17), with
time shown in the format
“
HH-MM
”
. Time is set in the same
manner as the date (2.3.1). To confirm the selected values,
press
“
ЕNTER
”
.
To return to
“
SETTINGS
”
, press
“
ESC
”
.
Fig.17
2.3.3 Interface Language Setup
To set the language, select
“
LANGUAGE” in the
“
SETTINGS
”
menu using the and keys, and
press
“
ENTER
”
. The interface language will change from Russian to English. To set Russian, select the
menu item
“
РУССКИЙ ЯЗЫК
”
and press
“
ENTER
”
.
Upon setting the language in the
“
SETTINGS
”
mode, press
“
ESC
”
to return to the Start Menu.
2.4 ELECTRONIC SWITCH CONTROL MODE (
“
SWITCH
”
)
The
“
SWITCH
”
mode is only available when the Electronic Switch is connected to the Main Unit.
This mode is intended for testing low-current lines. It allows running tests over all possible two-wire
combinations in a multiple-wire cable (up to 8 cores, in the current version).
As the
“
SWITCH
”
mode is the main one for testing low-current lines, it is readily accessible from the
Start Menu, as well as from
“
LOW FREQUENCY AMPLIFIER
”
,
“
WIRED RECEIVER
”
,
“
NONLINEAR JUNCTION
DETECTOR
”
, and
“
REFLECTОMETER
”
modes.
2.4.1. Main Screen of the
“
SWITCH
”
Mode
To access the
“
SWITCH” mode from the Start Menu (Fig.18), using the and keys
highlight
“
SWITCH
”
and press
“
ENTER
”
. The main menu of this mode will appear on screen
(Fig.18).
Fig.18
The numbers in Fig. 18 represent:
1 – current mode
2 – wire pair connected to the input of the device
3 – wire pair selection
4 – red frame highlighting the current menu item
that can be adjusted
5 – voltage in the selected wire pair (DC and AC)
6 – engaged contacts of the Electronic Switch
connector (RJ45)
7 – hotkey assignments