Rostock Max Assembly Guide
69
22 – Wiring the Power Switch & RAMBo Power
22.1 – Take the included power switch and remove all the mounting hardware from it. The
mounting point is ¼” thick and there won’t be any room except the outside nut when it’s time to install
it.
22.2 – Cut one black wire and the green wire from the large 22 pin plug on the power supply.
Solder the black wire to the center lug on the switch and the green wire to one of the outside lugs –
make sure that the lugs you’re soldering to are in line. If you solder to one of the end lugs that are not
in line with the center lug, the circuit will not be completed when the switch is closed. I recommend
using heat shrink tubing to protect the exposed joints from shorting out against anything.
Figure 114 - Power Switch wired.
22.3 – Install the switch in the hole marked “Power” as shown. To orient the switch correctly,
rotate it so that the toggle is pointing down towards the green wire. If you draw an imaginary line along
the center of the toggle, it will “point” to the lug it’s in contact with. When in the “on” position, you
want it pointing to the green wire. Simple!
Figure 115 - Power switch installed.
