Rostock Max Assembly Guide
66
21.13 – Trim off the “skirt” from two crimp-on wire nuts – this will help them clear in the limited
space available once the Hot End is mounted on the delta platform.
Figure 108 - Skirt trimmed from the crimp-on wire nut.
21.14 – Route the power wires through the Hot End Adapter Plate and crimp each one to a
resistor wire pair. Note that if you so choose, you can route the wires on the outside if you’ve trimmed
enough of the grey insulation back. This would give you a bit more room to work with when mounting
the Hot End.
Figure 109 - Power wires connected to the resistors.
