Rostock Max Assembly Guide
48
17 – Idler Assembly
17.1 - Using the 9 remaining bearings, assemble the idler bearings using two idler spacers and a
608 bearing for each. See photo below:
Figure 76 - Idler Bearing
17.2 - Install two idler bearings at the bottom of each tower. Prepare six #6-32 1.75" socket
head cap screws with #6 washers. Install each idler pulley as shown in the photos below.
Figure 77 - Lower Idler Bearings Installed
17.3 - It may be easier to install the parts if you lay the Rostock Max down on its side. Note that
the "inner" idler bearing must be installed first or you won't be able to reach its location past the
"outer" idler bearing.
