Rostock Max Assembly Guide
22
8.4 - The nut should only be installed about one turn. There needs to be room for the rail
to slide easily for installation in the next step.
8.5 - Carefully slide the three rails over the t-slot nuts - the fit may be a bit tight if you don't have
the t-nuts loose enough.
Slide rail down to meet the scribe line marked on the panel.
Figure 30 - Rail Installed to Alignment Line
8.6 - Tighten screws only enough to hold the rail in place - this will be adjusted and tightened up
later in the build process.
Figure 31 - All Three Rails Installed
