Rostock Max Assembly Guide
15
4 – Install the Connectors on the Stepper Motors
4.1 – If you’re installing the RAMBo or other controller board on the inside face of the
electronics mounting plate/door, you only need to add extension wires to the stepper motor for
the Z axis. If you’ll be installing the LCD controller, the drive electronics
must
be installed on the
inside of the electronics mounting plate. If the electronics are installed on the outside face of
the electronics mounting plate, you’ll need to test fit each stepper motor in order to determine
which ones will require an extension cable.
4.2 – Using the included wire, the extension wiring pattern goes like this:
Stepper Wire
Extension Wire
Red----- ---------------------Red
Black------------------------Black
Green----------------------Green
Blue------------------------White
4.3 - The crimp on connector is wired in this order:
Pin 1 – Red
Pin 2 – Blue (White if using the extension)
Pin 3 – Green
Pin 4 – Black