Rostock Max Assembly Guide
56
19.6 - Thread the wires down the central shaft of the extrusion using the fishing line - simply tie
a looped knot (a granny knot) around both wires just ahead of the crimp on connectors - make
sure you've twisted the wires together a bit as it makes pulling them both a bit easier. Thread
the fishing line down the tower and pull the extra out to the left side - that is the side that the
wire exit slot is on. When you're done, the top should look like this:
Figure 89 - Properly routed End Stop wiring.
19.7 - At the bottom of the tower, the wire should exit the rail as shown in Fig. 90.
Figure 90 - Wire exiting the tower rail.
19.8 - Make sure that the wires pass through the wiring slot to the left as shown above. Pull
wire on all three towers. We'll be coming back to them later, so don't attach the plastic connector shells
to them yet.
