
89
Fig. 87 - Battery Installation
Battery Installation
• Slide a
new
3 volt type CR2450 Lithium Battery, negative
(-) side down into the Battery Cavity from the right side
and ensure that it slides under the contact clip on the left
rim of the cavity.
• Orient the Retaining Bar across the lower portion of the
Battery and carefully push it down into position (Fig. 87).
Battery Hatch and Hatch Ring Installation
• Lightly lubricate the
new
Hatch O-ring with silicone
grease and place it on the inner rim of the Battery Hatch.
Ensure that it is evenly seated. This O-ring must be a
genuine SEEMANN part that can be purchased from an
Authorized SEEMANN Dealer. Use of any other O-ring
will void the warranty.
• Slide the Ring, top portion first, onto your thumb (Fig. 88).
• Carefully place the clear Battery Hatch (with O-ring) into
position on the rim of the Battery Compartment, then
press it evenly and completely down into place with your
same thumb.
• Maintain the Battery Hatch securely in place and, using
your other hand, slide the Hatch Ring down off your
thumb and into position around the Battery Compartment.
The tabs on the Ring fit down into the slots located at the
2 and 9 o'clock positions (Fig. 89).
Fig. 88 -Hatch Installation
Fig. 89 -Orientation of Hatch Ring
Содержание XP5
