Seastar Solutions i7700, Руководство по установке

Страница: 30 / 60

5-2
© 2017 SeaStar Solutions i7700 Installation Supplement, Rev. B
Once you are satisfied with the shift and throttle performance the sea
trial is complete.
After returning the vessel to port, check that none of the electrical
harnesses and wiring are exposed to water, excessive
temperatures, or mechanical damage. Check that all wire splices
are properly secured, sealed, and dry. Check that all unused CAN
connectors are properly sealed with sealing plugs.
You must also properly secure the actuator adjustment jam nuts
(section 4.2):
• Remove the cable access covers.
• Loosen and back off the adjuster barrel jam nuts at the actuators.
• Apply a drop of Loctite Threadlocker Blue 242 to the threads
adjacent to the adjuster barrel.
• Tighten the jam nuts against the adjuster barrels.
• Install the actuator cable covers. Be sure to install them to the
correct actuator, because the labels that you applied during
installation give manual override instructions specific to the
actuator’s type and instance
5.4 Conclusion of Sea Trial
Enter Trolling Mode and check that full throttle gives a satisfactory
fraction of maximum, and that the low speed control is precise.
Adjust the Trolling Max Throttle parameters (section 4.3) if necessary.
If there are two control stations, run the vessel from both. Transfer
control between control heads and verify that transfer works as it
should. If you can’t transfer control, check that the Station Protection
feature is not enabled.