Seastar Solutions i7700, Руководство по установке

Страница: 24 / 60

4-2
© 2017 SeaStar Solutions i7700 Installation Supplement, Rev. B
5.
For each shift actuator set the Shift to Forward Direction
parameter (figure 4-2) to Push or Pull to match the direction the
actuator is required to move to engage
forward gear. Don’t
adjust the other parameters yet.
6.
For each throttle actuator set the Acceleration Direction
parameter to Push or Pull to match the direction the actuator is
required to move to
increase throttle.
7. Remove the actuator covers if you haven’t already done so.
8.
Move the port and starboard control head levers to the forward
and reverse gear positions and verify that the shift actuators
move accordingly. Confirm that the control levers are controlling
the correct actuators. If not, revisit step 2.
Figure 4-2. Shift setup screen.
Figure 4-3. Throttle setup screen.
See table 4-1 at the end of this
section for typical actuator
parameters. This information is
provided for reference only, and
should be verified before use.