5.
Install the manufacturer-supplied software on a PC (refer to
for details.)
6.
Connect the data I/O cable to the PC and double-click on
UCI
to start the software.
7.
Push
Connect
in the software to turn on the sensor.
8.
Set up the sensor for deployment (refer to
Configure sensor with deployment wizard
on page 20 for details.)
9.
Verify that the boss seal on the SeaFET V2 is screwed in all the way.
The sensor will flood if the plug is not screwed in all the way.
10.
Immediately before the SeapHOx V2 is deployed, connect the plumbing to the
SBE-37.
a.
Use a 5/32" hex key to remove the three screws that attach the wet cap to the
pressure housing.
The clean seawater in the wet cap will drain.
b.
Remove the two threaded plastic plugs and install the manufacturer-supplied flow
cells with the wet cap (refer to
on page 29 for
details.)
c.
Install the flow cell again. Make sure the fitting is securely connected to the
exhaust port on the MicroCAT.
d.
Secure the two plastic plugs into the wet cap again.
11.
Connect a dummy plug to the Y-cable for deployment.
N O T I C E
Make sure that the screw-in boss seal is tightened or the sensor will flood and void the
warranty.
12.
Transmit and process data that is stored in the sensor to the PC (refer to
on page 25for details):
a.
Connect the sensor to the UCI software and PC and start the software.
b.
Push
Transmit Data
in the Dashboard of the software.
c.
Select "All Data" or "Sample Number Range" in the Data Transmit Options area.
d.
Select either "UTC" or "Local" time stamp in the CSV Format Options area.
e.
Enter a new file name or use the automatically generated file name.
f.
Push
Transmit
.
The software copies the data to the PC in both a raw
.sbsdat
format and a
converted
.csv
format.
13.
Immediately after the SeaFET V2 or SeapHOx V2 is recovered from a deployment
(refer to
Recover sensor from deployment
on page 23 for details):
a.
Use the software to turn off the sensor.
b.
Disconnect the fittings from the flow cell, fill the flow cell with clean seawater and
secure the two red plugs to keep fresh water out of the flow cell.
c.
Rinse the sensor with fresh water.
d. SeapHOX
: Disconnect the Y-cable and remove the SBE-37 from the mounting
bracket.
e. SeapHOx
: Clean the flow path of the SBE-37.
14.
Dry and lubricate the bulkhead connectors. Refer to
on page 37 for details.
15.
Attach the protective dummy plugs and lock collars.
16.
Refer to
on page 38 for details to prepare the sensor for
short- or long-term storage.
SeaFET V2 and SeapHOx V2 quick start guide
4
Содержание Deep SeapHOx V2
