Sea-Bird Scientific Deep SeapHOx V2, Руководство пользователя

Страница: 19 / 56

7. Use a 7/64" hex key to loosen the captured screw in the battery cover plate.
8. Remove the battery pack from the pressure housing.
9. Turn the yellow cover plate counterclockwise to remove it from the battery pack body.
10. Move each of the two O-rings on the outside of the battery holder from the grooves.
It makes it easier to remove or insert batteries.
11. Examine the O-rings and surfaces for dirt, cuts, or other damage.
Clean or replace as necessary.
12. If necessary, remove the batteries in the pack.
13. Insert new batteries.
Make sure to alternate the positive (+) and the negative (-) ends on the batteries to
agree with the labels on the pack as they are installed.
14. Move the O-rings back into the grooves.
15. Align the pin on the yellow battery cover with the post hole in the battery pack
assembly.
16. Align the "D"-shaped part of the battery pack with the pins on the shaft.
17. Slowly move the assembly onto the housing. Push gently to connect the battery
assembly with the circuit board in the pressure housing.
18. Use a 7/64" hex key to tighten the captured screw on the yellow battery cover onto
the shaft in the pressure housing.
19. Important ! Remember to attach the Molex connector on the end flange to the
connector on the top of the guide pylon in the pressure housing.
Set up sensor and verify function
17