SCS PTC-IIex, Руководство пользователя

Страница: 71 / 220

6 Commands
•
PACTOR connections to be established using the HAYES command interpreter.
•
PACTOR connections to be established using the Free-Signal-Protocol.
Only these operating conditions are decreasing the trial counter, which represents the
remaining quantity of test connections using the feature respectively. As soon as the trial
counter reaches zero, the features are not available any more unless a valid license code is
entered. Other features than mentioned above are not not affected and with this still
available after the trial period is exceeded.
6.47 LIN
Default setting: 128
Parameter: X 20... 128, Number of characters before an auto linefeed.
Auto linefeed after X transmitted characters (word wrap). The auto linefeed is turned off
with the value 128.
6.48 LIst
Remote
Lists the contents of a directory in the PTC mailbox.
The short-form
L
for the
LIst
command is also accepted by the remote station, as in
this case no possible confusion with
Listen
can occur!
The output format is valid also for the
DIR
command (refer to chapter 6.36 , page 52 )
Examples:
L
DK5FH Lists all messages for DK5FH.
L
DK5FH 4 Lists the message no 4 for DK5FH.
L
DK5FH 4- Lists from message no 4 onwards for DK5FH.
L
DK5FH 3-5 Lists messages 3 to 5 for DK5FH.
L
ALL Lists all messages in the directory ALL.
L
ALL 4-5 Lists the messages 4 to 5 in the directory ALL.
L
5 Lists message no 5 in the current directory.
L
List all messages in the current directory.
6.49 Listen
Default setting: 1
Parameter: 0 Listen mode disabled.
1 Listen mode enabled.
2..4 reserved
5 Listen PACTOR-I only
The Listen mode is turned on with
Listen
1, so that it is possible to 'Listen-in' to what
is being sent in PACTOR QSO and to read Unproto transmissions. Listen is only possible
in the STBY condition. If the Listen mode is active Connect packets are also monitored
57