SCS PTC-IIex, Руководство пользователя

Страница: 85 / 220

6 Commands
R
TEST 3 Reads message number 3 in the TEST directory.
R
DL2FAK Reads message no 1 for DL2FAK if only one message exists.
Outputs the contents of the DL2FAK directory if more than one
message exists.
R
DL2FAK 1-3 Reads messages numbers 1 to 3 for DL2FAK.
R
PTCPLUS 4- Reads from message number 4 onwards in the PTCPLUS directory.
6.80 RELOad
RELOad
overwrites the present BBS contents!!
RELOad
enables a BBS backup file to be read back into the BBS. After the
RELOad
command, the PTC waits for a valid Backup file. As soon as the PTC receives a correct
header (
###PTCBAK
), it begins to load the BBS files. The
RELOad
procedure is
prematurely aborted if the fileheader is faulty.
At the end of the loading procedure, the PTC performs a checksum comparison, and then
gives a message saying whether during the
BAKup
/
RELOad
procedure an error had
occurred or not. The
RELOad
procedure can then be ended with a Plus (+) character.
6.81 REMote
Default setting: 1
Parameter: 0 Remote control disabled.
1 Remote control enabled.
This command permits the access to the remotablecontrol commands for a distant station.
With
REMote
1 the remote commands are enabled. The other station can now use all the
commands signified with remote . All these commands must, however, have the remote
control characters // prefixing the commands (e.g. //
Write
test or //
Dir
).
The remote sequence "//" must be placed at the beginning of a new line, to be valid.
The
REMote
command should be set to 0 for 7plus transmission.
Also, directly after a connect, or CHANGEOVER to receive, the PTC-IIex is internally at
the beginning of a new line, and thus processes the directly following // sequence as a
remote control sequence, this limitation of only being accepted at the beginning of a new
line increases the data transparency quite considerably.
Multiple remote control commands are allowed. Each command must end with a <CR>.
A single command does not need the <CR> to end it, if a CHO character immediately
follows the command. System messages of the remote controlled PTC are transmitted in
lower case, as this gives better Huffman compression, and a clearer display.
The Remote control access may be blocked with
REMote
0.
6.82 RESEt
Remote
Soft reset of the System!
71