Schwing SPB 28, Руководство по эксплуатации

Страница: 134 / 216

42
Overview
SPB Operation Manual
Pairing Transmitter to Receiver
Pairing is necessary to get a unique assignment be-
tween a single Transmitter and a single Receiver. When
replacing either the Receiver or Transmitter in a system
follow the procedure below:
1. Turn the main power switch on the control panel to
the “On” position (Figure 1).
2. Clear the E-stop, by pressing and then turning
counter-clockwise (Figure 2).
3. Remove the battery from the Transmitter. Tether
Transmitter to the Control Panel with the provided
Connection Cable (Figure 1).
Connection Cable
Transmitter
Figure 1
Tether Transmitter to Control Panel
4. Make sure all Transmitter switches are either in the
“off” or “neutral” position. Stroke Limiter Dial must
be turned to “1” (Figure 2).
E-Stop
Power Button
Power LED
Stroke Limiter
Snail / Rabbit Switch
Figure 2
Transmitter switches and buttons
5. Open the control panel door. Press the Receiver
Power Switch to the “off” position (Figure 3).
Receiver Power Switch
Off
On
Receiver ID Window
Figure 3
Receiver power switch and ID window
6. Press and release the E-Stop button on the Trans-
mitter (Figure 2).
7. Press the Receiver Power Switch to the “on” posi-
tion (Figure 3).
8. Within 45 seconds press and hold the power but-
ton on the Transmitter for approximately 10 sec-
onds until the power LED (right of the E-Stop)
illuminates solid RED. The Receiver ID Window
should display PO:ID . The ID will now be sent to
the Receiver.
=
9. Press and release the E-Stop button on the Trans-
mitter (Figure 2).
10. Press and hold the Power Button until the
Power LED illuminates solid RED (Figure 2).