Maintenance
07.00 | GSM-P | Assembly and Operating Manual | en | 389104
45
Ø
Pull the gripping module (31-34) from the DKM GSM housing.
Ø
For elastomer variants, proceed as follows:
Remove the back stops (83) after loosening the nuts (124).
Also remove the needle rollers (122).
Ø
For shock absorber variants, proceed as follows:
Remove the dampers (120) after loosening the nuts (121).
Also remove the sleeves (122).
Assembly
For assembly, observe the permissible tightening torques as well
as the greases and adhesives to be used;
Screw tightening torques
[
}
40] and
Grease/greasing areas
[
}
39].
Ø
Lubricate the DKM GSM housing (11) and the bushing (44 or 46)
on the running surfaces and bearings.
Ø
Grease the bearing ring (82).
Ø
Insert the bearing ring with the outer chamfer downwards into
the DKM GSM housing.
Ø
Lubricate the O-rings (103) and mount them into the recesses
on the bushing (44 or 46).
Ø
Insert the gripping module into the DKM GSM housing.
Ø
Adjust the axial bearing seat of the bushing with the fitting disks
(111 or 112).
Ø
Set DKM stop 1 (81) onto the bushing and fasten it to the bush-
ing using the screws (140).
Ø
Grease the DKM ball guide (85).
Ø
Turn the bushing so that DKM stop 1 (81) is pointing 180° away
from the bore holes for the damper.
Ø
Lubricate the needle rollers (122) and put them into the appro-
priate fits.
Ø
For elastomer variants, proceed as follows:
Lubricate the needle rollers (122) and put them into the appro-
priate fits.
Place one ball (142) in the housing in front of each needle roller
(122) and screw the DKM back stop 2 (83) into the housing.
Ø
For shock absorber variants, proceed as follows:
Grease the sleeves (122) and put them on the dampers (120).
Insert the sleeve into the provided fit in the DKM GSM housing
(11) and screw the damper into the housing.
Place one ball (142) in the housing in front of each sleeve (122).
Ø
Mount the locknut (124) onto the stops/shock absorbers.
Ø
Connect the DKM module (11) to the FAN rotor drive using the
screws (104). When doing this, pay attention to the assembly of
the basic modules
Disassembly/assembly of the unit in the basic
modules
[
}
40].