Assembly
07.00 | GSM-P | Assembly and Operating Manual | en | 389104
17
Mounting the Unit
Mounting the unit on the base side
(with adapter plate similar to A, B or C; see "Mounting the GSM at
the side and on the base side")
The assembly of the unit can be carried out from the side of the
unit using the screws (6).
There are threads in the housings for mounting from the cus-
tomer-specific opposite side (screws 5 and 6 are not included in
the scope of delivery).
Centering sleeves (2) are to be used for the secure transmission of
shearing forces and positioning of the unit.
Mounting the unit at the side
(with adapter plate similar to A, B or C)
The assembly of the unit can be carried out from the side of the unit
using the A2 screws included in the accessory pack (3A, 3B or 3C).
For mounting from the customer-specific opposite side, there are
threads in the housings (the A2 screws (4A, 4B or 4C) are included
in the accessories pack).
Centering sleeves (1A, 1B or 1C) are to be used for the secure
transmission of shearing forces and positioning of the unit.
NOTE
In order to guarantee process reliability for monitoring with mag-
netic switches, most especially the adapter plates and the attach-
ments located near the unit should be made of non-ferromagnetic
material. Otherwise, monitoring with magnetic sensors could be
impaired considerably
Accessories
[
}
6].
NOTE
When monitoring with magnetic switches, a minimum distance of
10 mm is to be observed between the units in the event of the as-
sembly of several units next to each other
Accessories
[
}
6].