5.
Remove the brake pedal.
Replacement
1.
Position the brake pedal in the pivot bracket.
2.
Install the brake pedal pivot shaft with two
nylon bushings, and two machine bushings.
3.
Attach the brake pedal rod to the brake pedal.
4.
Install the access panel into the opening in the
bottom of the operator compartment.
5.
Connect the battery.
Brake Adustments
Brake Pedal Height
Specification: 4.75 ± 0.25 inches (see Fig. 4)
1.
Disconnect the battery and discharge the
capacitors.
2.
Remove the top cover and the control cover.
3.
Disconnect the rod end on the brake rod from
the brake lever arm.
4.
Loosen the jam nut on the brake rod end.
5.
Rotate the rod end to lengthen or shorten the
brake rod. (Rotating the rod end
counterclockwise will lower the brake pedal,
rotating the rod end clockwise will raise the
brake pedal.)
6.
Tighten the jam nut on the rod end.
7.
Attach the rod end to the brake lever arm.
8.
Check the height of the brake pedal and
repeat steps 3 through 7 if necessary.
9.
After the brake pedal height has been
adjusted, verify that the brake switches are
adjusted properly.
10. Install the control cover and the top cover.
11. Connect the battery.
Brake Switches
1.
Disconnect the battery and discharge the
capacitors.
2.
Remove the top cover and control cover.
3.
With the brake pedal released, loosen the
screws securing the brake switch. Move the
E
lectric
C
ounterbalance
H
igh
O
utput
Brakes
REV W1 12/02/99
3.4
Figure 4 - Brake Pedal Height
