SCAN 70 gas insert / ZC-fireplace, Инструкция по установке и эксплуатации

Страница: 45 / 64

45
7. Operation
7.1. Before you begin
Warning: Read the entire manual before you use your insert / ZC-fireplace (especially page 3 “Safety Precautions”).
Failure to follow the instructions may result in property damage, bodily harm, or even death.
Warning: Do not operate the insert / ZC-fireplace with any of the glass panels removed, cracked or broken. A li-
censed or qualified person should do the glass replacement.
Warning: Do not abuse the door such as striking at them.
Controls location:
On/off switch: This control is used to turn the flame on and off.
Optional blower control: This knob turns on and controls the speed of the internal convection blower that pushes
heated air into the room.
Gas control knob: This knob controls gas to the insert / ZC-fireplace pilot. There are three positions; ON,
OFF, and pilot. The indicator line is to the left of the knob.
Flame adjust knob: This knob controls the flame height from low (“LO”) to high (“HI”). The indicator line is
above the knob.
Pilot igniter: The pilot igniter is used only to start the pilot. When pressed, it sends an electrical charge to
the pilot assembly. This creates a blue spark directly next to the pilot, igniting the pilot
flame.
Remote control: If using a remote control with thermostat, the on/off switch must be “OFF”. Turning the
on/off switch “ON” will keep the insert / ZC-fireplace on always.
An instruction card for operation of the insert is at-
tached to the inside of the insert / ZC-fireplace.