Scan-Graphics CF1000/44, Руководство по эксплуатации

Страница: 39 / 50

2-21
2. Press the Down Arrow key until the option you wish to use or set
appears in the keypad display.
Repeatedly pressing Down Arrow steps through the available options in
sequence, as shown in Figure 2-10.
Figure 2-10 Options One through Four - Keypad Display Examples
Alternately, you may press Up Arrow repeatedly to see them in reverse
sequence.
3. When the desired option appears in the keypad display, stop.
•
For each option, the left side of the keypad display contains the
following information: (1) the option number; (2) the option name;
and (3) the current parameter setting, if any applies.
•
For each option, the right side of the keypad display steps through
the possible choices for using that option. An example of this is
shown in Figure 2-12.
Each choice is preceded by the key you must press to select it. (The
Opt key always represents the choice to Exit the option, without
proceeding or changing a parameter.)
4. Press the appropriate letter key or Opt to choose the desired state (or
setting) for the option.
The next sections describe the choices available for each option.
5. Repeat Step 4 for each option you want to choose or change.
After you've selected the desired choice for all options, go on to Step 6.
6. Press Opt again to get out of the selection mode and activate your
option choices.
1.Data Format: BINARY A: GRAY
2.Autocalibration A: PROCEED
3.Reboot Scanner A:PROCEED
4.Save Parameters A:PROCEED