SawStop JSS-120A60, Руководство пользователя, Страница: 82 / 100

Extra caution is needed when making
plunge cuts, since the blade guard,
riving knife, and anti-kickback pawls
cannot be used .
1
4
5
6
2
3
You can clamp a board on top of workpiece,
if it cannot easily be clamped to table.
i
A plunge cut is used to create a slot or
opening somewhere other than the edge of
the workpiece.
Fully lower blade. Position fence at desired
cut width and lock in place. Position
workpiece flat on table and flush against
fence.
Clamp workpiece to table using clamps and/
or featherboards. If plunge cut will be start of
longer cut, use featherboards. If blade will be
raised and lowered while workpiece remains
stationary, clamp workpiece directly to table.
Turn on motor. Slowly raise blade to desired
height (partially into or all the way through
workpiece).
If making a stationary plunge cut, slowly
lower blade and turn off motor.
If making a long plunge cut, use a push block
or push stick to slowly and smoothly advance
workpiece to desired end point of cut. Slowly
lower blade and turn off motor.
Turn saw off and wait for blade to stop fully
before removing workpiece.
PLUNGE CUT
82
|
SawStop ® Jobsite Saw Pro