SawStop JSS-120A60, Руководство пользователя, Страница: 21 / 100

wood is too wet. See the instructions on starting the saw in Bypass Mode ( see page 50 ) and how to
test the conductivity of a material ( see page 51 ). If the test indicates the wood is too wet to cut with
the safety system active, you must either allow the wood to dry or make the remaining cuts in Bypass
Mode.
8)
Do not replace the arbor belt with a non-SawStop belt. The SawStop arbor belt is custom designed to
dissipate static electricity that may build up on the spinning blade which could cause an unintended
activation of the brake.
9)
Never touch the arbor, arbor pulley, arbor nut or arbor washer when the blade is spinning because
you may receive a serious injury. These parts are all electrically coupled to the blade and the brake will
activate if contact with these parts is detected.
10)
Never reach under the blade while it is spinning. In the event the brake is activated, the retraction of the
blade may cause a serious injury if you contact the bottom of the blade.
11)
Do not remove the dust shroud because a large portion of the blade will be exposed. If you contact the
blade under the table, the blade may retract toward you and cause a severe injury.
12)
Do not unplug or disconnect the saw from electrical power before the blade has stopped spinning. If
the power is interrupted while the blade is moving, the safety system will not be active and therefore the
brake will not activate in the event of accidental contact. You may receive a serious injury if you contact
the spinning blade while the electrical power has been interrupted.
13)
Never attempt to disable the SawStop safety system or modify the electrical wiring of the saw in any
way. Any change or modification or disablement of the safety system or other wiring could result in a
serious injury and will void all warranties.
14)
Never attempt to repair, adjust, modify or otherwise service a brake cartridge. There are no user-
serviceable parts inside the brake cartridge. The brake cartridge is permanently sealed against dust and
other contaminants. Destruction, removal, or alteration of this seal voids all warranties.
SawStop ® Jobsite Saw Pro
|
21