SATO S84NX, Руководство оператора, Страница: 143 / 588

143
(2) Paper end detection level (fixed)
(3) Gap sensor waveform
*1 The paper end distance can be set in the [Printing] > [Advanced] > [Paper End] > [Paper End
Distance] menu.
Conditions That Trigger Paper End in the Printing Operation
1. The paper end sensor detects a no-paper condition at the position where feeding is done to the
distance detected in the following table.
Paper End
Sensor
Paper End
Distance (mm
(inch))
Setting Method
I-mark Sensor 15 (0.59") Fixed
Gap Sensor 15 to 400 (0.59"
to 15.75")
Set by the [Printing] > [Advanced] > [Paper End] > [Paper
End Distance] menu or command
2. If the amount of printing remaining is less than the distance between the print head position and
paper end sensor - the paper end distance shown in the table above, a paper end error occurs
after completing the output of
1
.
If the amount of printing remaining is more than the distance between the print head position and
paper end sensor - the paper end distance shown in the table above, a paper end error occurs
right after detecting the paper end, and the printer will reprint after clearing the paper end error.
(1) Print head position
(2) Paper end sensor: I-mark sensor/Gap sensor
Select in [Printing] > [Advanced] > [Paper End] menu, or specify by command.
(3) Paper end distance
(4) Media feed direction
If a paper end error is detected while printing, operation varies depending on the amounts of printing
and media remaining when the error was detected.
The amount of media remaining can be calculated as follows: