Satec PM172EH Series, Инструкция по установке и эксплуатации

Страница: 44 / 90

38 Chapter 4 Setup Menus
2
Operate/release actions via relays are automatically recorded to the event log
whenever an electrical quantity, status input or phase reversal trigger is used.
3
Setpoint operation and release are recorded to the event log.
4.9 Timers Setup Menu
Î Î Î Î
This menu allows you to access the two interval timers provided by the
PM172EH which can trigger setpoints on a user-defined time interval
basis. This is useful for continuous data logging at specified time intervals
in order to produce trend and load profile graphs.
Each timer has a time interval range up to 9999 seconds at a one-second
resolution and runs independently. The timer accuracy is about
±
0.05 sec.
To use a timer as the trigger for a setpoint, simply select one of the timers
as a trigger when defining the setpoint, and then specify for the selected
timer a non-zero time interval at which you want the periodic action (for
example, a data log) to be made. To stop a timer, set the time interval to
zero. Each timer can be used to trigger multiple setpoints, for example, if
you need multiple data logs at the same time.
Timer setup
To select a timer:
9 Press to activate the middle window,
and then use the up/down arrow keys to scroll
to the desired timer. The time interval
associated with the timer is displayed in the
lower window.
To change the timer interval:
9 Press to activate the lower window.
9
Use the up/down arrow keys to set the desired
time interval. The available range is 0-9999
(seconds). Setting the interval to zero stops
the timer.
9 Press to store your new setting.
9 Press to leave the timer setup unchanged.
To quit the timer setup menu:
9 Press .
SELECT
t-r
1
t-r.1
SELECT
ENTER
ESC
ESC
SELECT
CHG
t-r Ï
Ð
ENTER
ENTER