16
15
LCD Monitor Instructions
Mode
Adjustment Procedure
1
Display the Windows or other screen
After a computer is connected with this LCD monitor, activate a computer and
then shows a bright screen on this LCD monitor. It might not be possible to adjust
the screen correctly for a dark screen.
Display the OSD (On Screen Display) Menu
Press the [MENU] button to display the following menu.
For DOS mode, run an application that shows the edges of the screen (edit
etc.) to adjust screen.
Before Adjustment
picture
advanced
pip
adv pip
options
utilities
Main menu
(Ex.)
Sub menu
brightness
50
-
+
contrast
50
-
+
H position
50
-
+
V position
50
-
+
phase
15
-
+
1056
frequency
-
+
scaling
Wide
The signal timing for a computer which this LCD monitor supports is listed in "Table of
Preset Data" on Page 56, the recommended value of Vertical Frequency for this model
is 60Hz. (Unlike CRT Monitors, the display becomes stable when Vertical Frequency is
low.) It is recommend to set Vertical Frequency of a computer connected at 60Hz by
"refresh rate setting" before starting adjustment procedure.
• To leave the Main menu, press the [MENU] button again.
2
You can change or indicate the signal input type following the steps.
Change or indicate the input signal
1.
While the OSD (On Screen Display) is not displayed, it is possible
to change or indicate the current mode.
Press the [
] button to indicate the current mode in the lower right
corner of the screen.
Analog RGB1
Mode: 88
1024 x 768 / 75 Hz
(Ex.)
2.
While displaying the current mode, press the [
] button again.
Start searching another mode according to the order [
Analog RGB1
]
/
[
Analog RGB2
]
/
[
Digital RGB
]
/
[
Composite Video
]
/
[
S-Video
]
/
[
Component Video
]
/
[
RGB + C Sync
] in sequence.
[
Analog RGB1
]
/
Switch to the signal from RGB connector.
[
Analog RGB2
]
/
Switch to the signal from R/G/B/HD/VD connector.
[
Digital RGB
]
/
Switch to the signal from DVI connector.
[
Composite Video
]
/
Switch to the signal from Composite Video connector.
[
S-Video
]
/
Switch to the signal from S-Video connector.
[
Component Video
]
/
Switch to the signal from Cr/Y/Cb connector.
[
RGB + C Sync
]
/
Switch to the signal from R/G/B/C SYNC connector.
• Every time the input signal is searched, display the searched and stop
searching picture.
• The current mode is indicated for each input signal type as follows:
Analog RGB1
Mode: 88
1024 x 768 / 75 Hz
Component Video
NTSC 60Hz/3.58MHz
RGB + C Sync
NTSC 60Hz/3.58MHz
Digital RGB
Mode: 88
1024 x 768 / 75 Hz
S-Video
NTSC 60Hz/3.58MHz
Analog RGB2
Mode: 88
1024 x 768 / 75 Hz
Composite Video
NTSC 60Hz/3.58MHz
In case there is no signal when the screen is on, the screen will be in the waiting
mode and nothing is shown.
NOTE
