Bedienungsanleitung / User manual
VDC-727IR-WM, VDC-727IR-WBJB
_________________________________________________________________________________
- 59 -
Take the speed dome out of the box.
It is recommended to set the dome parameters,
i.e. the DIP-switches, prior to the dome mounting
(also see chapter 2.3).
Hang the installation wire (which is fixed at one
end inside the dome cover) over the pin (also see
picture on page 58).
(It might be necessary to fix the wire on the pin to
prevent it from coming off again.)
Connect the cable plug to the dome.
Now put the speed dome onto the cover and turn
it tight (bayonet lock).
Take the dome cover out of the speed dome box.
Seize the cover to the wall bracket thread (also see
picture below).
Please make sure that the screw holes are freely
accessible and are not hidden by the bracket (this is
important for the later speed dome mounting).
Then use an Allen wrench to tighten the lower of the two
safety screws.
Freely accessible screw holes
Rubber gasket 50 mm
