Nivel System CLS-3
Laser Detector
User Manual
ver.
EN
1. Put dry batteries into the battery case and pay attention to the
right electrode.
2. Press the key ON/OFF to make the detector power on, and the
POWER indicator lights.
3. Move the detector upward(/downward) or left(/right) at 45
degree angle of the laser measured. When the laser hits the
receiving window, Both an audible buzzer and the related LED lights.
4. Locating horizontal laser, set the detector vertically, then move it
upward or downward to keep the round bubble in the center of the
circle.
Locating vertical laser, set the detector horizontally, and then move
it left or right to keep the long bubble locating at the center of the
long vial.
5. When the laser line hits the center of the receiving window, the
green LED(the one at middle) lights and buzzer will be in a
continuous beeping.
6. Move the detector toward to the direction which the red LED
indicates, and buzzer sound discontinuous beep.
7. Renew the battery when the power indicator starts to wink
slowly.(Low voltage alarm.)
8. The detector will shut off automatically in 7min without any
operation.
Attentions:
1. This kind of detector only fit for Cross line laser level.
2. The detector is precision instrument, must avoid the environment with high temperature & high
dampness/aquosity.
3. Please remove the battery when not using.
Specification:
Cooperation (laser beam)
red, green
Detection accuracy
±1
Receiving distance
70m
Working temperature
- 10
℃
～
+ 50
℃
Power
DC9V alkaline battery
Size of receiving window
20mm×21mm
IP Rate
IP54
Connection thread
1/4”
Detector adapter
yes
Dimension
140x60x25/mm3
Weight
126g
Nivel System – Service & supprot
TPI Sp. z o.o., ul. Bartycka 22, 00-716 Warsaw, Poland
phone.: +48 22 632 91 40, [email protected]
www.nivelsystem.com
