SANDVIK CH420:01, Руководство по установке

Страница: 25 / 110

2. Safety precautions
23 CH420:01 © Sandvik SRP AB – Doc. no. S 223.510 en Ver. 1
Avoid remaining on the crusher, unless necessary for maintenance work.
2.3.1 Machine safety guards
Upwardly ejected fragments may fall down in the vicinity of the crusher.
Therefore Sandvik recommends additional protection.
Platforms with guard rails shall be installed around the crusher’s feed
opening. Walkways, stairs and ladders must be designed in accordance with
applicable regulations. (These parts are not included in the crusher’s standard
specification).
Make sure all defective guards and dust sealing components are checked,
repaired and replaced before starting the equipment.
DANGER!
Risk of crushing
Never remain on the crusher while crushing. Moving parts constitute a
risk of crushing. Falling into the crusher implies danger of being
crushed.
WARNING!
Risk of crushing
If the crusher is mounted on rubber dampers, there is a risk of
crushing between the oscillating parts of the crusher and the
stationary frame.
WARNING!
Ejection
Never look into the crusher while crushing. Fragments and possibly
harmful substances fed to the crusher may be ejected.
PROHIBITION!
Do not remove guards
Make sure that all guards are in place and functioning, to prevent
exposure to flying fragments and rotating parts. Never operate the
equipment unles guards are mounted.
WARNING!
Rotating parts
Exposure to rotating parts of the equipment shall be prevented by
guards. Always attach guards after maintenance work.
WARNING!
Flying fragments
Fragments ejected upwards may fall down in the vicinity of the
crusher. Provide adequate guards and warning signs at appropriate
places around the danger zone.