S&C 6800 Series, Инструкция

Страница: 17 / 40

S&C Instruction Sheet 1045-510 17
Installation
Install the switch control at the site, and configure the equipment as described
below.
The following steps can be completed in the shop or later at the installation site. The steps
are summarized here, and described in detail in the other IntelliTeam instruction sheets.
1. Install the IntelliLink Software on your computer.
For details, see Install IntelliLink Software in S&C Instruction Sheet 1045-530.
2. If this switch control uses a modem for communication, configure the modem.
For modem confi guration instructions, see the manufacturer’s documentation or
contact S&C.
3. If this switch control uses a radio, configure the radio.
For radio confi guration instructions, see the manufacturer’s documentation or contact
S&C.
4. If a repeater radio is needed to link this switch control to the other team
members, configure the repeater radio.
For radio confi guration instructions, see the manufacturer’s documentation or contact
S&C.
5. Set up the control software in this switch control.
You can complete most of the software setup and confi guration in the shop. For an
explanation of how to set up the software, see
Switch Control and Team Setup in S&C
Instruction Sheet 1045-530.
Optional In-Shop
Setup
Communication
Connections
Communication data connections are at the bottom of the processor board on the back of
the control panel door. The connectors shown in Figure 14 are under the shield.
Figure 14. Communication connectors are on the bottom of the processor board.
SCADA Port B
SCADA Port A
Native Ethernet Port
Add-on Ethernet Port