S&C 6800 Series, Инструкция

Страница: 28 / 40

28 S&C Instruction Sheet 1045-510
Installation
7. For pad-mounted controls, connect and test the door switch.
a. Connect the switch control’s 3-pin connector to the harness from the door switch
of the low-voltage cabinet. This step can be skipped for factory installed
controls.
b. Press the door switch lever, and make sure that this turns OFF the faceplate LEDs
and LCD panel. When you release the lever, the LEDs and LCD should come back
ON. If they do not, see S&C Instruction Sheet 1045-550.
The switch control uses the door switch status to know when to provide power
to the faceplate LEDs and LCD. If the low-voltage cabinet does not have a door
switch, contact the manufacturer.
If necessary, make sure that the communications equipment has power. For overhead
switch controls the communications equipment is on the back of the faceplate. For
6800 Series Switch Controls installed in pad-mounted gear, the communication
equipment is not mounted inside the 6800 Series chassis.
Remove any temporarily-installed bypass that was applied at Step 3 on page 19.
This makes the switch control available for local, non-automatic operation from the
faceplate.
Ç
WARNING
Be sure to leave the switch control in SCADA Control LOCAL (not REMOTE)
and Automatic Operation DISABLED (not ENABLED) mode until configuration
of the software in the switch control has been completed.
This completes hardware installation and testing. The following pages of this
instruction sheet contain the installation and wiring diagrams.
Go to the Setup Instructions S&C Instruction Sheet 1045-530.
Check Communication
Equipment
Put the Control Into
Local/Non-Automatic
Service