S&C 6800 Series, Инструкция

Страница: 15 / 40

S&C Instruction Sheet 1045-510 15
Installation
WiFi Option
In a 6801 enclosure the WiFi transceiver is mounted on the Comm Plate (Figures 9 and 13),
but if there is a gateway communication option it is mounted to the enclosure. In pad-
mounted gear the WiFi transceiver is mounted on the Comm Plate, see Figures 10 and 13.
For a pole-mounted enclosure the WiFi antenna is mounted on the bottom, and for pad-
mounted gear a dual GPS/WiFi antenna is installed on the top of the low-voltage enclosure.
See Figure 11 on page 16. The WiFi transceiver communicates to the Serial Port on the
control panel, see Figure 12 on page 16.
Figure 9. The WiFi transceiver is connected to the same power supply as the processor
board, and communicates to the front panel Serial connector.
Figure 10. In pad-mounted gear the WiFi transceiver is mounted to the Comm Plate in the
low-voltage enclosure.