S&C 6800 Series, Инструкция

Страница: 22 / 40

22 S&C Instruction Sheet 1045-510
Installation
Figure 19. Connection terminal for ac control power.
Ç
WARNING
Leave the 10-ampere
AC LINE
fuse
out
until instructed to replace it later in the
installation process. Leave the ac control power de-energized until you are instructed
to turn it on.
1. If necessary, install the battery.
The switch control is normally shipped with a factory installed battery. If your control
needs a new battery, or the battery was shipped separately, install it now.
Ç
WARNING
If the enclosure heater was recently on, the battery bracket may be hot. Be careful
not to touch a hot bracket.
The battery bracket is near the high voltage section of the PS/IO circuit board. When
installing the battery, make sure the 10-ampere
AC Line Fuse is removed and the ac
control power is de-energized. If your control is powered from the sensors, you must
also disconnect the switch interface cable(s).
a. The battery bracket is located on the right inside the enclosure. See Figure 20.
Connect the Battery
Figure 20. Battery and bracket on the right, inside the switch control enclosure.