Samyung ENC SMR-715 series, Инструкция по эксплуатации

Страница: 151 / 192

125
Chapter 9 MAINTENANCE AND CHECK
9.4.1 PARTS REQUIRED FOR PERIODIC REPLACEMENT
There are parts required for periodic replacement.
PARTS NAME INTERVAL
MAGNETRON 4,000 HOURS
MOTOR 10,000 HOURS
In many cases, parts required for periodic replacement works interval hours or more,
but if it is over the interval hours it is recommended to replace the early.
The occurrence of phenomenon when parts were consumed)
Magnetron: The radar sensitivity decreases, and it becomes difficult to take the tune.
Motor: Allophone generation and rotation instability or stop.
Parts life time might become remarkably short by vibration of radar mast
more than product standard.
9.5 FAULT FINDING
9.5.1 ALARMS AND OTHER DISPLAY LISTS
If any of the following alarm occurs, the system displays the alarm message in red in order to attract the
attention of operator. Other messages are displayed with the suitable color which is yellow or blue depending
on the level of message importance.
The following table shows alarms and other indications the system displays.
Alarm Code Alarm Name Class Description
S001
Alarm Error Alarm
Cannot send the alarm because of insufficient message buffer for
alarm task.
S002
Scanner(AZI) Alarm
The BP error bit of scanner communication data is set.
S003
Scanner(HL) Alarm
The BZ error bit of scanner communication data is set.
S004
Scanner(MHV) Alarm
The high-voltage modulator error bit of scanner communication
data is set.
S005
Scanner(Time out) Alarm
No reply from the scanner after data communication.
S006
Scanner(Data) Alarm
Collision occurs when transmitting data to the scanner.
Checksum of the received data is different.
S007
Scanner(EEPROM) Alarm
Stored value error is returned from the scanner when the initial
adjustment data is requested.
The save operation is not completed when data save is
requested to scanner EEPROM.
S008
Scanner(Heater) Alarm
The MAG heater voltage error bit of scanner communication data
is set.
S009
Scanner(Video) Alarm
The VIDEO error bit of scanner communication data is set.
S010
Scanner(Trigger) Alarm
The TRIGGER error bit of scanner communication data is set.