English -
11
Installation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside
of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage
of plastic surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.
For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting
wall. If the oven is to be installed below a hob, the hob’s installation instructions should be followed.
595
370
560
545
21
595
Max.50
Min.550
Min.560
Min.50
Min.590 ~ Max.600
Min.460 x Min.50
Built-in
0
5
5
550
2
7
5
572
595
370
560
545
21
85
Max.506
595
175
Max.494
Min.550
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
0
5
5
550
2
7
5
572
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.
Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent
cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and
inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power
supply and release the 2 screws on the both sides of the oven.
WARNING:
The built-in furniture must have a minimum ventilation gap for Air-flow as shown
in picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
NV70F7796ES_EE_DG68-00522D-01_EN.indd 11
2015-05-21 �� 6:51:07