Samson TROVIS 5432, Монтаж и эксплуатация

Страница: 31 / 38

8. Installation and electrical connections
8.1 Installing the controller
The controller is made up of the casing section and the base. The casing contains the elec-
tronic components, the LC display and the control knob. The base contains the terminals.
Important: The casing section must be separated from the base before the controller can be
installed and wired. To do this, press down the tongue on top of the controller so that you
can remove the casing section from the base by tipping it forward.
The controller is designed for wall or panel mounting:
For wall mounting , use two or three screws to attach the base to a wall. The distances be-
tween the holes are shown in the dimensional diagram. For top hat rail mounting, an adapt-
er is available.
For panel mounting , push the casing section through the prepared panel cut-out (138 +1.0 x
92
+0.8
mm) and then fix it to the panel using the two threaded bolts M4 and the fastening
clips.
96
140
55.5
91
137
8
10
50 44.3
3
15
29.3
15
22
35
Base attachment
Bores for adapter
for top hat rail mounting
Fig. 6 ⋅ Dimensional diagram
EB 5432-1 EN
31
Installation and electrical connections