SAMLEX AMERICA INC. | 79
SECTION 5 |
Battery Charging in Evolution™ Series
!
ATTENTION!
S'assurer que la charge de tension, les paramètres connexes d'EVO
TM
comme (i) La tension d'absorption,
(ii) EQUALIZE VOLTAGE, (iii) Tension d'égaliser et (iv) La compensation de température (COMPENSATE) est
réglée / programmée pour correspondre aux paramètres programmés du contrôleur de charge externe.
[Veuillez consulter (i) le tableau 6.2, section 6 et (ii) les sections 4.4.2.2 à 4.4.2.5 du manuel d'utilisation de la
télécommande EVO-RC-PLUS].
5.5 BATTERY TEMPERATURE COMPENSATION USING TEMPERATURE SENSOR:
MODEL NO. EVO-BCTS
5.5.1 General Description – Battery Temperature Compensation
Please refer to Section 1.4.5 for general information on temperature compensation of battery charging voltages.
Battery Temperature Sensor Model EVO-BCTS
[Fig 2.5(a)]
has been provided to ensure optimum charging of Lead Acid and
Nickel Zinc (
Ni-Zn
) Batteries by
negative
temperature compensation of the charging voltages based on the battery electrolyte
temperature. The charging voltage is reduced when electrolyte temperature rises above the reference temperature of 25°C /
77°F and increased when electrolyte temperature falls below the reference temperature of 25°C / 77°F.
i
INFO
Charging voltages of Lithium Ion Battery are not affected by temperature and hence, Battery Temperature
Sensor Model EVO-BCTS is not required to be used when Lithium Ion batteries are used.
Automatic temperature compensation will be carried out over temperature range of -20°C to +60°C based on the
programmed value of the
negative
“Temperature Coefficient of Battery Charging Voltage”. In EVO™, this parameter
is called “COMPENSATE” and is specified in “mV/C/Cell”. For programming details of this parameter, please refer to
the following Sections of EVO-RC-PLUS Remote Manual:
• Parameter Setup Menu Map at Fig 4.2 under Section 4.1.3.1: Screen 5
• Programming range and defaults: Screen No. 5 of Table 4.3, Section 4.4.1
• Programming procedure: Section 4.4.2.5
In addition to compensating Absorption, Float and Equalization voltages, the voltage thresholds of parameters “LOW
VOLTAGE ALARM”, “BATTERY LOW VOLTAGE”, “RESET VOLTAGE”, “BATTERY OVER VOLTAGE” and “RESET TO
BULK” are also temperature compensated.
5.5.2 Constructional Details of Battery Temperature Sensor Model EVO-BCTS and Installation
The Temperature Sensor consists of 5 meters / 16.5 ft cable with Temperature Sensor Head for the battery end
[1 in Fig
2.5(a)]
and RJ-45 Plug
[2 in Fig 2.5(a)]
for EVO™ end.
Содержание Evolution EVO-4248SP
Страница 115: ...SAMLEX AMERICA INC 115 NOTES...