56 | SAMLEX AMERICA INC.
3.15.2 Constructional Details and Installation
The Temperature Sensor consists of 5 meters / 16.5 ft cable with Temperature Sensor Head for the battery end
[1 in
Fig 2.5(a)]
and RJ-45 Plug
[2 in Fig 2.5(a)]
for EVO
TM
end.
Temperature Sensor Head [1 in Fig 2.5(a)]:
The Temperature Sensor Head is installed on the Positive / Negative
battery Stud
[Fig 2.5(b)]
to monitor the temperature of the battery electrolyte. The Sensor Head contains an
embedded Negative Temperature Coefficient (NTC) Resistor with 2 internal terminals “NTC+” and “NTC -”.
Internal terminal “NTC+” is wired to Pin 4 of the RJ-45 Plug
[2 in Fig 2.5(a)]
and internal terminal “NTC -” is wired
to Pin 5 of the RJ-45 Plug.
RJ-45 Plug [2 in Fig 2.5(a)]:
The RJ-45 Plug is required to be plugged into the RJ-45 Jack marked “Battery Temp
Sensor” on the front panel of EVO
TM
[6 in Fig 2.1]
. Pinout of the RJ-45 jack is shown in Fig 3.12.
RJ-45 Jack on The Front Panel of EVO
TM
[6, Fig 2.1] for Connecting Battery Temperature Sensor.
Pinout of this RJ-45 Jack [marked “Battery Temp Sensor” on the front panel of EVO
TM
[6 in Fig 2.1)]
is shown at Fig 3.12:
1 2 3 4 5 6 7 8
+5V
Internal
Schematic
of EVO
TM
Batt Temp
to DSP
1K
5.1K
Fig 3.12 Pinout of RJ-45 Jack marked “Battery Temp Sensor” on the front panel of EVO
TM
[6 in Fig 2.1].
3.16 INSTALLING CONTROL INPUT WIRING FROM LITHIUM BATTERY MANAGEMENT
SYSTEM (BMS) TO ENABLE / DISABLE CHARGING OR INVERTING
Refer to Section 5.11.2 regarding
“Stop Charging”
or
“Stop Inverting”
protections for Lithium Ion Batteries
when parameter “BATTERY TYPE” is programmed for Option 2 - “1=Lithium”
(See programming details at Section
4.4.2.22.2 in the Owner's Manual for Remote Control EVO-RC-PLUS)
.
The Battery Charger Section of EVO™ is designed to charge 3 types of batteries - Lead Acid / Nickel Zinc (Ni-Zn)
/ Lithium Ion. Lead Acid and Nickel Zinc (
Ni-Zn
) battery charging voltages are required to be compensated based
on the temperature of the battery cells. Hence, Battery Temperature Sensor Model EVO-BCTS is required to be
connected to the RJ-45 Jack marked "Battery Temp Sensor"
[6, Fig 2.1]
as explained at Section 3.15.
SECTION 3 |
Installation
Содержание Evolution EVO-4248SP
Страница 115: ...SAMLEX AMERICA INC 115 NOTES...