Salicru SLC TWIN PRO Series, Руководство пользователя

Страница: 30 / 44

30
6.1.4. Main screen.
• UPS control panel provides useful information about the
status of the load, events, measures, identification and setting
through the screen of the front panel.
• Immediately after the start up, the LCD panel shows the
SALICRU logo for few seconds and next the main screen
by default is displayed, where the status of the equipment is
represented (figures 17 and 18).
• When the same menu is displayed for 15 minutes in the LCD,
and there has not been any manipulation over the buttons, it will
return back to main screen automatically.
• The main screen shows the following information by default:
ˆ
Summary of the status, including the operating mode and
load.
ˆ Status of the alarm, if there is any one active.
The alarm includes the fault and warning informa-
tions.
ˆ
Battery and status of the charge, including the battery
voltage, charge level and charger status.
ˆ Continuous information includes the UPS in parallel and
running time.
UPS output
information
Information of load
level connected to
the UPS
Equipment
operating mode
Battery information
UPS power supply
information -single
phase input-
Fig. 17. Main screen of the equipment with single phase
input
.
Information of load
level connected to
the UPS
UPS power supply
information -three phase
input -
UPS output
information
Equipment Battery information
Fig. 18. Main screen of the equipment with three phase input.
•
All the screens shown in the figures of this chapter correspond
to an equipment with three phase input. Only figure 17 shows
the main screen of single phase input equipment, in order to
compare it with figure 18, which is for a three phase equipment.
A part from the difference as regards to battery voltage,
power that belong to the model, the values phase to neutral
or phase to phase and neutral can be appreciated.
• For more details about the representations in the LCD of the
control panel, see next section 6.2.
6.2. Operating modes of the
equipment.
•
The different graphical symbols displayed in the LCD of the con-
trol panel, correspond to the following operating modes or status:
ˆ
Normal mode:
The UPS is running on normal mode with power supply
present.
Fig. 19. Normal mode screen.
ˆ
Battery mode:
When the UPS is running on battery mode, the alarm
beeps every 4 seconds.
Fig. 20. Battery mode screen.
ˆ
Bypass with output voltage:
The output voltage that feeds the load comes from the
commercial mains directly through the internal filters.
This way the loads are not protected against mains faults
or blackouts. The acoustic alarm beeps every 2 minutes.
Fig. 21. Bypass with output voltage screen.
USER MANUAL