Sakai SW884, Руководство оператора

Страница: 49 / 127

2 OPERATION
– 44 – – 45 –
2) Remove the plugs (2 locations) from the motor.
NOTE: Conduct the work rapidly, as the oil will gush out when the plugs are taken off.
3) Screw in the removed bolts with the washers into the plug holes. Screwing in them until
they become a little tight will disengage the brake.
NOTE: Wash clean the brake release bolts and blank plugs before fitting to the motors.
4) After towing, replace the bolt and washer to original position and tighten the plug securely
to the motor.
2.2.5 Steering wheel position adjustment
1) Pull the lever
ⓐ
upward. Doing so disengages the lock
off the wheel.
2) Position the wheel for your operating comfort.
3) Lower the lever
ⓐ
to lock the wheel in place.
2.2.6 Operator’s platform position adjustment
Operator’s platform rotates by 60 and 90 degrees,
clockwise or counterclock – wise.
Set it at the desired angle to allow you to easily see the
drum edge during work.
1) While depressing the swivel pedal
ⓑ
, rotate the
operator’s platform by pushing or pulling with your
other foot.
2) As soon as it starts rotating, release the swivel pedal
ⓑ
and continue to push the operator’s platform at 60
degrees, it will automatically lock into position.
3) Continuing the same action while depressing the swivel lever
ⓑ
will allow the operator’s
platform to lock automatically at 90 degrees.
WARNING
Make sure the operator’s platform is completely locked in place before continuing
to operate the machine. If the operator’s platform is not locked in place, it could
unexpectedly rotate during operation and cause the operator to lose control of the
machine and result in an accident with the potential for injury or death.
CAUTION
Sit down on the seat during this operation for your safety.
ⓑ
ⓐ