5
6
7
3
1
2
4
3
2
1
180
Changing the bulbs
NOTE
Use only tested, incandescent bulbs with the ‘E’ designation.
Use of non-approved bulbs will void the operating license. Do
not touch the bulbs with bare fi ngers. Hold bulbs with a clean,
dry cloth when installing or re mov ing them.
Headlight
1 = low beam bulb S3 12V 15W E9
2 = low beam bulb S3 12V 15W E9
3 = Position light bulb
12V/3W
- Remove the screws (4) on both sides.
- Detach the rubber cover (5) from the headlight.
- Release the holder clamp (6) and remove the bulb (7).
- Pull the position light (3) with the bulb holder carefully out of
the headlight housing.
- Assemble in reverse order.
NOTE
When assemble, bend the holder clamp (6) for a safety
contact.
Tail / brake light bulb
The tail light is not fi tted with a replaceable light bulb (diode
light).
If the tail light does not work you should fi rst check, whether a
cable connection is interrupted.
- Push back the cable protection (2) underneath the seat.
Check the cable connections (3) green/ yellow, green and
black.
If this is not the case, the tail light must be replaced.
ELECTRICAL SYSTEM
Содержание madass
