cutting in, never start the engine until the battery is fully charged!
Follow the battery manufacturer's instructions regarding
safe handling and disposal.
3.5 GRASS-CATCHER SUPPORT
ASSEMBLY
Fit the two brackets (1) on the rear plate (2),
using for each bracket three screws (3)
which are supplied, as shown, without fully
tightening the nuts (4).
Hook the upper part of the grass-catcher
frame (5) onto the brackets and centre it up
with the rear plate (2).
Adjust the position of the two brackets (1) to
the stop (6) so that, when turning the grass-
catcher frame, the pin (7) slots into the seat
(8) correctly.
Check again that the frame (5) is properly
centred with the rear plate (2) and that it
rotates correctly, as shown above, and then
fully tighten the screws (3) and the nuts (4).
3.6 REMOVAL OF THE STOP FROM THE HOOKING PAWL
OF THE GRASS-CATCHER
For transport purposes, the pawl (1) hook-
ing the grass-catcher is held onto the rear
plate by a stop (2).
This stop must be removed before fitting the
grass-catcher brackets, and is not to be
subsequently used.
!
WARNING!
UNPACKING AND ASSEMBLY
11
EN
1
1
2
2
4
3
5
5
6
1
8
7
2
1
