Ryobi WS720, Руководство оператора

Страница: 8 / 44

8 — English
UNPACKINg
See Figure 4, page 16.
This product requires assembly.

Carefully lift the saw from the carton and place on a level
work surface.
WARNINg:
This new product has been shipped in a partially
assembled condition as described below. Carefully check
the packing list below to ensure all items are included in
the package. The packing list describes all loose items
that are not assembled to the product as shipped. Do
not operate the product if any packing list items are
already assembled to your product when you unpack it.
Call the customer service number below for assistance.
Operation of a product that may have been improperly
preassembled could result in serious personal injury.

Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKINg LIST
Tile saw
Bevel table
Splash hood with knob and hex bolt
Splash hood bracket
Screws (2)
Overflow drain
Rip guide
Miter guide
Hex wrench
Arbor wrench
Support bracket “A”
Support bracket “B”
Stand legs “A” (2)
Stand legs “B” (2)
Leg stand brace (2)
Leg stand nut (2)
Leg stand bolt (2)
Operator’s Manual
ASSEMbLy
WARNINg:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNINg:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNINg:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
INSTALLINg ThE SPLASh hOOD
See Figure 5 - 6, page 16.

Remove bevel table.
 Install the L-shaped splash hood bracket into the lip
located under the table behind the wheel.

Install the washers and screws into table and through
splash hood bracket then tighten securely.
NOTE: Be sure that hood bracket is aligned with cutting
wheel so that it does not interfere with material being
cut.

Align splash hood with wheel and slide over bracket. Line
up through holes in splash hood with slot in splash hood
bracket.
NOTE: Always adjust splash hood horizontally to table
and slightly above tile thickness. Hood should not be
touching tile.

Install hex bolt through hood and bracket. Thread knob
onto bolt and tighten to desired height.
 Replace bevel table.
INSTALLINg ThE RIP gUIDE
See Figure 7, page 17.

Turn knob on rip guide counterclockwise to loosen.
 Slide rip guide onto side of table.

Use rip guide scale, located on front and rear of table, to
set rip guide to desired width of cut.
 Turn rip guide knob clockwise to tighten securely.
INSTALLINg ThE MITER gUIDE
See Figure 7, page 17.

Adjust rip guide to desired position and secure.

Slide miter guide onto rip guide from front.