Runco D-73d Ultra, Руководство по установке и эксплуатации

Страница: 79 / 152

Installation
D-73d Series Installation/Operation Manual 63
Corner/Midpoint Alignment — 16:9 Aspect Ratio:
1. Select the 16:9 aspect ratio using either the Dimension Digital Controller remote
control unit (see Figure 2-6) or the OSD menu (press MENU , then select Aspect
Ratio -> 16:9 ). This should move the anamorphic lenses out of the optical path.
2. On the Dimension Digital Controller remote control or front panel, press MENU .
3. Select Calibration from the Main Menu.
4. Select Adjustment Mode from the Calibration Menu and set it to Secondary .
5. Select Image Alignment from the Calibration Menu.
6. Select Corner Alignment to correct a “keystoned” image by adjusting the image
corner positions. Select Midpoint Alignment to correct pincushion distortion by
adjusting the image edge mid-points. See Figure 3-29.
Figure 3-29. Image Alignment Controls
This procedure is normally performed only on the right
(secondary) optical engine.
Use the built-in test pattern when adjusting the image corners or
midpoints. To access it, check the
Secondary (or Primary ) Test
Pattern box in the Corner Alignment or Midpoint Alignment menu.
Note
Tip
Top Left (x, y)
Left
Middle (x)
Left/Right
Middle (y)
Right
Middle
(x)
Bottom Left (x, y)
Top Right (x, y)
Bottom Right (x, y)
Top/Bottom Middle (x)
Top Middle (y)
Bottom Middle (y)
Notes:
1. Smaller “x” values move a point to the left; larger values move it to the right.
2. Smaller “y” values move a point up; larger values move it down.
Center
(x, y)