Runco D-73d Ultra, Руководство по установке и эксплуатации

Страница: 72 / 152

Installation
56 D-73d Series Installation/Operation Manual
11. Adjust Horizontal Offset on Left (Top) Primary Lens: To shift the projected
image horizontally, insert the provided hex wrench into the horizontal lens shift
adjuster at the top of the projector. Then, turn the wrench as shown to shift the lens
in the desired direction.
12. Lock Left (Top) Primary Lens Position and Zoom Settings: When you have
finished adjusting the lens position and image size (zoom), insert the provided hex
wrench into the lens lock access hole at the front of the projector. Then, turn the
wrench clockwise two or three full turns to lock the lens position.
Right (Bottom) Primary Lens Adjustment:
1. On the Dimension Digital Controller remote control or front panel, press MENU .
2. Select Calibration from the Main Menu.
3. Select Adjustment Mode from the Calibration Menu and set it to Secondary .
4. Press EXIT (or MENU ) repeatedly to return to the Main Menu.
5. Select Service from the Main Menu.
6. Select Test Video from the Service Menu and choose Secondary Alignment .
7. Perform Steps 8 through 12 above with the right (bottom) primary lens.
When you have completed the primary lens adjustments (D-73d/CineWide with
AutoScope only):
Remove the anamorphic lenses and set the lens transport motor
power switch to the “on” position.
Adjusting the Picture
Orientation
By default, the D-73d is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1. On the Dimension Digital Controller remote control or front panel, press MENU .
2. Select Service from the Main Menu.
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation .
5. Select Orientation , then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to
match the installation method.
THE LENS SHIFT MECHANISM CAN BE DAMAGED BY
EXCESSIVE FORCE.
• Ensure that the lens lock is released before adjusting
horizontal or vertical lens shift.
• Do not attempt to move the primary lenses beyond their
normal adjustment ranges.
WARNING
➤