External Port
The M18010-CM module provides five external ports:
USB port: By connecting to the USB port, USB storage devices can store logs, host version, alarms and other
diagnosis information, facilitating online upgrade of switch software and storage of logs.
To secure data and prevent damage to the device, it is recommended to use high-quality flash disks
produced by reliable manufacturers. The USB port is compatible with most USB controllers but may be
unable to identify some USB disk models.
SD card slot: By connecting to the SD card slot, SD memory cards can store logs, host version, alarms and other
diagnosis information, facilitating online upgrade of switch software and storage of logs.
To secure data and prevent damage to the device, it is recommended to use high-quality SD memory cards
produced by reliable manufacturers. The SD card slot is compatible with most SD memory cards but may be
unable to identify some SD memory cards.
The USB flash disk must be installed to the USB port before you upgrade the software.
Console port: As a serial communications port, it uses the RS-232 interface level and standard RJ-45 connector.
This port is used to connect the serial port of terminal computers running on the background for such tasks as
system debugging, configuration, maintenance, management, and host software loading.
10/100/1000M MGMT port: As the 10/100/1000BASE-T Ethernet port, it uses the RJ-45 connector. This port can be
used to connect the device to the Ethernet port of the background computer to load programs. Use the standard
cable to connect the device to the Ethernet port of the background computer.
DCMI port: As the 10/100/1000BASE-T Ethernet port, it uses the RJ-45 connector. This port can be used to connect
the device to the Ethernet port of the background computer to manage the device. Use the standard cable to connect
the device to the Ethernet port of the background computer.
Data Center Manageability Interface (DCMI): DCMI implements the management for the data center devices. For
example, you can check the temperature, configure the serial port, reset the device, and power on/off device. These
operations cannot be achieved through the Console port or the MGMT port. Use the standard cable to connect the
device to the Ethernet port of the background computer.
Button
The M18010-CM module provides a Reset button, which is used to reset the system. If the button is held for less than five
seconds, it is a short press; if the button is held for five seconds or longer, it is a long press.
In case of a short press of the button, the Status LED flashes in green, and the device resets within five
seconds. In case of a long press, the Status LED flashes in green and then flashes in red; the device resets
within five seconds.
Press the button, and the system starts to collect information, during which the device will not restart. After
the collection is complete, the device restarts automatically. Hold the button for a while and release it, the
device restarts automatically in five seconds.
LED
LED
Identification
on the panel
Status
Meaning
Off
The module is NOT receiving power.
Solid red
The module is faulty.
System LED
Status
Blinking green Initialization is in progress. Continuous blinking indicates
Содержание RG-N18010
